How to use
 required wind pressure
 Wrap the air duct with a cloth. Which should be the air hose used with the AIR BRUSH, especially the air pressure in the range of 1 to 4 kgi/cm2. It is recommended to adjust the air valve to get the proper air pressure. And use an air filter to filter water, oil, dust that may come in the wind.
 the type of paint used
 Can use watercolor ink without the need to mix any ingredients but poster paint. And the water-based paint must be of high quality, it is necessary to add an anti-clogging agent to the Ladgehr or Challad. because there will be a fog on the paint layer if the substance is not added
 Spray method
 Connect the wind to the spray gun, first press the Push Button to complete. Then let go to let the four colors pass. And when you're done, make sure your fingers are not pressed against the button under any circumstances. It should be sprayed before the actual spraying when the needle, nozzie and cap are clogged so it must be cleaned immediately after use.
 Rules after use
 After use, be sure to spray water. Or solvent (Soivent) through the spin to clean the device in several cycles.
 After the needle thread has been removed, pull the needle back about 10 mm and when the air cap is removed, clean any dirt that has accumulated inside the spinner. by blowing air through the gun several rounds
 Clean the gun that has accumulated in it by pulling out the needle.
 Care should be taken when cleaning or removing layers, especially the needle, nozzle and cap, which are small, expensive, and prone to damage.